Table of Contents
Advertisement
Set IP Address and Port by
SMS
Enable GPRS Function
Set Time Interval for
Sending GPRS Packet
Output Control
Output Control (Safe
mode)
This function is achievable
when the speed is below
10km/h and GPS is
available.
Set power saving mode
when MT08 is still
(In power saving mode, GPS
stops working. GSM enters
standby
mode
and
sending out message until it is
activated by an SMS or an
incoming call)
User Manual of MT08
Name, APN Password
W******,012,IP, Port
W******,013,X
W******,014,XXXXX
W******,020,P,F
W******,120,ABCDE
W******,026,XX
stop
- 27 -
no password required, just
insert APN
name only;
APN defaulted as 'CMNET';
APN name + password not
over 39
characters.
IP: xxx.xxx.xxx.xxx
Port: [1,65536]
X=0, close GPRS (default);
X=1, enable TCP
X=2, enable UDP
XXXXX should be in five
digitals and in
unit of 10 seconds.
XXXXX=00000,to disable this
function;
XXXXX=00001~65535, time
interval for sending GPRS
packet and in unit of 10
seconds.
P =1, Out1
=2, Out2
=3, Out3
=4, Out4
=5, Out5
F =0, to disable the output
=1, to enable the output
ABCDE
represents
Out2, Out3,
Out4, Out5 respectively.
If A or B or C or D or E,
=0, to disable the output
=1, to enable the output
=2, to remain previous status
XX=00,
to
disable
function
XX=01~99,
to
set
function. It is in
unit of minute.
Example:
If XX=10, MT08 will enter
power
saving mode in 10 minutes
Out1,
this
this
Advertisement
Table of Contents
