Operation - Axminster SX2.7 Original Instructions Manual

Operation

1. Before starts to use this machine, operator should go through the instructions carefully
so as to acquaint with the construction of the machines, the functions of the various
controls and also the driving systems.
(1) Insert the power line insert the socket right of the
fuselage, then power on;
(2) Loosen the emergency stop switch (B), then the spindle speed display (D) bright
and show "0000", press the start button (A) then clockwise rotation of the speed control
button (C), can make the spindle speed raise to the highest position. Under these
circumstances the mill only have forward direction. Under tapping circumstances have
forward and reverse direction. Press the tapping function lock button (E), then is button
will bright, then you can press a green button to choose the spindle run to forward or
reverse. The green button total 3 pcs, they on the right of the spindle box in the lifting
lever. You can see the word of forward or reverse on the right of the display (D), it easy to
show the user the direction of the rotation of the spindle.
Notice:
（1） In general, it is only in an emergency that a snap stop switch is needed to stop the
spindle from turning. Do not often use the emergency stop switch (B) stop the machine, it is
bad to the main PC Board.
（2） After using should turn the power switch to position '0' and press the emergency
stop switch (B), then pull out the power plug from socket.
7