Table of Contents
Advertisement
Section I – Introduction
A. Purpose Of Manual
This manual describes the basic operational characteristics
and provides service, overhaul and parts information for the
Vickers FCGT–02 Electrically Modulated Flow Control. The
information contained herein pertains to the latest design
series as listed in Table 2.
B. General Information
1. Related Publications – Installation dimensions are
not contained in this manual. The installation drawing listed
in Table 1 is available from any Vickers application engineer-
ing office or from:
Vickers, Incorporated
Technical Publications
5445 Corporate Drive
P. O. Box 302
Troy, MI 48007-0302
Model Code
1
Flow control valve
2
Check valve included
3
Manifold or subplate mounted
1
2
3
4
5
6
7
4
With torque motor for
remote control
1
/
inch size
5
4
6
A – Model with sleeve for lower
flow ranges
B – Model without sleeve for
higher flow ranges
Table 2. Model Code Breakdown
2. Model Codes – Variations within each basic model
series are covered in the model code. Table 2 is a complete
breakdown of the model codes covering these units. Service
inquiries should always include the complete unit model
code as noted on the nameplate.
Model
Drawing
FCGT–02–A–004–11
FCGT–02–B–004–11
FCGT–02–A–028–11
FCGT–02–B–028–11
FCGT–02–A–220–11
FCGT–02–B–220–11
FCGT–02–A–530–11
FCGT–02–B–530–11
Table 1
8
9
Number x 10 equals resistance in ohms/
7
coil, e. g. 004 x 10 = 40 ohms
004 –
028 – 280 ohms
220 – 2200 ohms
530 – 5300 ohms
Design & modification
8
F3 seals
9
513850A
40 ohms
3
Advertisement
Table of Contents
