ADJ FOCUS BEAM LED User Instructions page 21

SYSTEM MENU
DMX SETTINGS - The submenus listed under DMX SETTINGS are as follows: Set Address, DMX
Channel Mode, and No DMX Status.
• SET ADDRESS - In this submenu you can find and set your desired DMX address.
• DMX CHANNEL MODE - In this submenu you can find and set your desired DMX channel mode.
• NO DMX STATUS - This submenu setting is used as a precaution mode in case the DMX signal is lost
or interrupted. The operating mode chosen in this submenu is the running mode the fixture will go into
when the DMX signal is lost. Listed below are the 3 modes.
- This setting will have the fixture stay in the last DMX setup.
•
Hold Last
- This setting will have the fixture automatically go into stand by mode.
•
Blackout
- This setting will go into the current manual control set up. See MANUAL CONTROL.
• Manual
PERSONALITY - The submenus listed under PERSONALITY are as follows: Status Settings, Fan
Settings, Dim Modes, LED Refresh Rate, Gamma, Reset Motors, Display, and Service.
• STATUS SETTINGS - In this submenu you are able to access and adjust/change: Pan Degree, Pan
Invert, Tilt Invert, P./T. Feedback, P./T. Speed, and Hibernation.
NOTE: Pan Degree Added with software version
• FAN SETTINGS - In this submenu you are able to select your desired fan speed setting.
• DIM MODES - In this submenu you are able to select your desired dimmer mode and adjust the
dimming speed time.
• LED REFRESH RATE - In this submenu you are able to select your desired LED refresh rate.
• GAMMA - In this submenu you are able to select your desired gamma setting. NOTE: Remove from
≥
software version
• DIM CURVE - In this submenu you are able to select your desired dimmer curve setting. NOTE: Added
with software version
• RESET MOTORS - In this submenu you are able to reset selected motors.
• DISPLAY - In this submenu you are able to adjust the display intensity, invert the display, activate the
display blackout, and activate/deactivate the display lock.
• SERVICE - In this submenu you are able to access and adjust/change: the calibration (effect adjust),
activate the service port, update software, and restore the factory settings.
MANUAL CONTROL - This menu is for manual testing and manual control. Pan, tilt, color wheel, gobo
wheel, prism 1, prism 1 rotation, shutter, dimmer, focus, frost can all be tested/adjusted.
NOTE: The Prism and Frost features CANNOT be used at the same time.
1.0.3.
≥
1.0.4
≥
1.0.4
21