ADJ FOCUS BEAM LED User Instructions page 13

FIXTURE INSTALLATION
When installing the unit, the trussing or area of installation must be able to hold 10 times the weight
without any deformation. When installing the unit must be secured with a secondary safety attachment,
e.g. and appropriate safety cable. Never stand directly below the unit when mounting, removing, or
servicing the unit.
Overhead mounting requires extensive experience, including calculating working load limits, installation
material being used, and periodic safety inspection of all installation material and unit. If you lack these
qualifications, do not attempt the installation yourself.
These installations should be checked by a skilled person once a year.
*SIDE MOUNTING
TO MAINTAIN
INTEGRITY, FIXTURE
BE INSTALLED WITH CABLES
FACING THE GROUND AT ALL
TIMES. WATER MUST EASILY
RUN OFF AND NOT COLLECT
AROUND CABLE CONNECTIONS.
The Focus Beam LED is fully operational in three different mounting positions, hanging upside-down,
mounted sideways on trussing, or set on a flat level surface. Always use and install a safety cable as a
safety measure to prevent accidental damage and/or injury in the event the clamp fails. Never use the
carrying handles for secondary attachment.
IP65 RATING
MUST
ALWAYS
CABLE WHENEVER INSTALLING
THIS FIXTURE IN A SUSPENDED
ENVIRONMENT TO ENSURE THE
FIXTURE WILL NOT DROP IF THE
CLAMP FAILS.
13
*SAFETY CABLE
ATTACH A SAFETY