High-Voltage Power Supply Pcb Assy - Brother HL-1020 Service Manual

(3) Remove the one M4x12 screw to remove the inlet holder. Then, remove the inlet
and the PCB.
Note:
When re-assembling the inlet holder and AC inlet, be sure to insert the part A of the
holder into the hole of the ferrite core.
Main Cover
3.12

High-voltage Power Supply PCB ASSY

(1) Remove the one M4x12 screw securing the high-voltage power supply PCB ASSY.
(2) Remove the film covering the PCB.
(2) Disconnect the HV flat cable from the PCB.
Taptite, bind
M4x12
Insulation Sheet
Inlet Holder
A
Fig. 3-21
Main Cover
Fig. 3-22
III-13
AC Inlet
Ferrite Core
High-voltage Power
Supply PCB ASSY
HV flat cable