Fixing Unit - Brother HL-1020 Service Manual

3.6

Fixing Unit

(1) Remove the two M4x16 tapping screws.
(2) Lifting the fixing unit, disconnect the thermistor connector on the EL PCB first, then
the two heater harnesses.
Taptite, cup M4x16
Thermistor connector
Note:
The eject sensor actuator may also be removed when removing the fixing unit. In this
case be sure to re-assemble the eject sensor actuator when re-assembling the fixing unit.
(3) Remove the two M3x12 tapping screws.
(4) Open the fixing unit cover along the open side of the fixing unit cover.
Taptite, bind M3x12
Pressure roller
Fixing Unit
Heater harness
(Blue)
Fig. 3-7
Fixing unit
v r
Fig. 3-8
Thermistor harness
Heater harness (Brown)
Fixing unit frame
III-6
Taptite, cup M4x16
EL PCB
Fixing unit cover
Shaft