Transmitter Function (With Enforcer Remotes); Arming (With Enforcer Remotes) - SECO-LARM SLI 820R Owner's Manual

NOTE: The following information regarding RF transmitter functions applies only if
ENFORCER remotes are used.
TRANSMITTER FUNCTIONS (with ENFORCER remotes)
1. Press the button to:
! Arm the alarm.
! Lock power door locks.
! Reset the alarm.
! Bypass an open zone.
2. Press the button to:
! Disarm the alarm.
! Unlock power door locks.
3. Press the button to:
! Operate channel 2 (such as popping the
trunk or rolling up the windows).
! Silently arm or disarm the alarm.
! Bypass the alarm's sensors.
4. Press the button to:
! Turn the siren ON in an emergency.

ARMING (with ENFORCER remotes)

There are two different ways to arm your alarm.
Tell your dealer which is best for you:
" Active Arming
Turn your ignition OFF. Close all the doors.
Then press the
and parking lights flash once, the alarm is fully
armed and the doors lock.
If the siren chirps 3 times, the alarm is either
waiting for the vehicle's delayed domelights to
turn OFF (if your vehicle is so equipped), or it is
ENFORCER SLI 820R/-4 Owner's Manual
button. If the siren chirps
Lock
Auxiliary
telling you that one of the
alarm's zones (a door, or
the hood or trunk) is either
open or is not functioning
properly. (See ZONE BYPASS, page 4). Also,
check to make sure your car's domelight
switch was not left in the ON position. These
chirps can be programmed off. See page 11.
" Passive arming
Passive arming works the same as if the car's
factory remotes are used (see page 3).
Unlock
Panic
Page 7