Table of Contents
Advertisement
DISARMING (with factory remotes)
To disarm the alarm, use the factory remote to unlock
the doors. The siren chirps twice and the parking
lights flash twice. What happens next depends on
how your alarm is set:
" Alarm set for active arming (SecureLock
The alarm is now completely disarmed.
" Alarm set for active arming (SecureLock
The system will automatically rearm and relock
the doors 30 seconds later unless a door is
opened during this time. This prevents accidental
disarming. During this 30-second period, the LED
flashes quickly. However, if the door, hood or
trunk is open during the 30-second re-arming
countdown, then the system is permanently
disarmed.
SMART DISARMING (for factory remotes only)
When using the factory remote lock button or by
pressing the lock button on the door panel to
enter armed mode, the alarm has a special
function in which allows you to automatically
disarm the alarm within the first 60 seconds by
turning ON the ignition key.
This is a very useful feature. When you first enter
into your car, you generally would lock your doors
EMERGENCY DISARM
If you lose your transmitter, you can disarm your
alarm with the ignition key and the "VEPLe" switch.
While your alarm is either armed or triggered, turn
the ignition switch ON. Within 15 seconds, press
and release the VEPLe switch 3 times. The siren
and the flashing lights stop if the alarm was
DOMELIGHT SUPERVISION
With this optional feature, whenever you disarm
the alarm, your car's domelights turn ON for 30
seconds. This helps find your car at night and
make sure no one is hiding in it. If the alarm is
ENFORCER SLI 820R/-4 Owner's Manual
" Alarm set for passive arming
The system will automatically rearm itself 30
seconds later. If a door is opened, the system
temporarily disarms. Closing the open door will
again cause the system to enter the 30-sec. rearm
OFF)
TM
period. However, turning the ignition ON during
the rearm period permanently disarms the alarm.
ON)
TM
NOTE — Secure Lock, if enabled, will lock the
doors when the system arms. Otherwise, the
doors do not automatically lock.
NOTE — Typically, when the alarm enters into
30-second re-arming countdown, the LED will
flash rapidly. However, if the alarm was triggered
prior to the 30-second re-arming countdown, the
rapid flashing will be replaced by the tamper
indicator LED flashing during the arming
coundown (see page 6).
for safety. You can do this by either pressing
either the lock button on the factory remote or the
lock switch on the door panel. Once the doors are
locked, the alarm will be in the armed mode.
However, you can automatically disarm the alarm
by turning the ignition ON within the first 60
seconds only. If you do not turn the ignition ON, the
alarm will remain armed.
triggered, and then chirp and flash three times.
The alarm is now in the valet mode (see VALET on
page 6). (Ask your dealer where the switch is
hidden.)
triggered, your car's domelights will continuously
flash. If ignition controlled domelight is enabled,
turning OFF the ignition will turn on the domelight
for 30 seconds.
Page 5
Advertisement
Table of Contents
