Table of Contents
Advertisement
ENFORCER SLI 820R/-4 Owner's Manual
IGNITION-CONTROLLED POWER DOOR LOCKS
Your alarm can be programmed for ignition-
controlled operation (doors lock when you turn the
VALET
Sometimes you may not wish your alarm to arm
when you leave your vehicle. (For instance, if you
leave your car with a valet attendant, you may not
want to teach him how the alarm operates.) If your
alarm is set for active (manual) arming, this is
easy — don't press the Lock button, and the alarm
will not arm. However, if your alarm is set to arm
passively, use the valet mode to prevent it from
arming.
To enter valet, first disarm the alarm and turn the
ignition ON. Within 15 seconds, press and
release the VEPLe button three times. The alarm
is now in the valet mode. The siren chirps and
the parking lights flash once to confirm. (Your
DUAL-STAGE SHOCK SENSOR
Your alarm includes a patented dual-stage shock
sensor.
The first stage (pre-intrusion alert) warns thieves
the alarm is armed. For instance, the alarm will
chirp three times and the parking lights will flash
three times if the sensor detects a light bump to
the vehicle. However, if a thief attacks the car with
sufficient force, the alarm will trigger. (Your dealer
can make the shock sensor more or less sensitive
to attack, depending on your vehicle.)
TAMPER INDICATORS & TRIGGER ZONE ID
If your alarm was triggered when you were away,
the siren will chirp two times and the parking
lights flash seven times when you disarm your
alarm. The LED flashes in quick cycles to show
where the car was violated as follows:
! 1 flash — The ignition was turned on.
! 2 flashes — The alarm was triggered via
panic on the ENFORCER remote.
Page 6
ignition ON, and/or unlock when the ignition is
turned OFF). Consult your dealer.
alarm also goes into valet when you use
emergency disarm. See EMERGENCY DISARM on
page 5).
To exit valet, just turn the ignition ON and, within
15 seconds, press and release the VEPLe button
three times. The siren chirps twice and the parking
lights flash twice to confirm that valet is exited and
the alarm is now disarmed.
If you press the Lock or Unlock button while the
alarm is in valet, the doors will lock or unlock,
and the parking lights will flash four times. The
alarm's emergency call for help and 2nd channel
output operate normally (ENFORCER remote only).
NOTE — When using the factory remote, the
shock sensor (and other add-on sensors), and
current sensing will not trigger the alarm until 60
seconds after the alarm is armed.
NOTE — When using the ENFORCER remote, the
shock sensor (and other add-on sensors), and
current sensing will not trigger the alarm until 4
seconds after the alarm is armed.
Ask your dealer about the shock sensor.
! 3 flashes — Shock
sensor or other add-on
sensor was triggered.
! 4 flashes — A door was opened.
! 5 flashes — The hood or trunk was opened.
! 6 flashes — The current sensing was triggered.
These "memory" flashes automatically reset
when the ignition is turned ON.
SECO-LARM U.S.A., Inc.
Advertisement
Table of Contents
