Section 8 - Additional Checks; General; Load Stability Indicator System - JLG Skytrak 3013 Operation & Safety Manual

SECTION 8 - ADDITIONAL CHECKS

8.1

GENERAL

If any of the following test results cannot be achieved, the system is not functioning
properly and the machine must be removed from service and repaired before
continued operation.
8.2

LOAD STABILITY INDICATOR SYSTEM

A. Load Stability Indicator System Test
The Load Stability Indicator (LSI) is intended to continuously monitor the forward stability
of the telehandler. This feature performs a two step check:
1. The first step (1 second duration) performs a test to verify the buttons. If this step
fails, red LED (1) begins to flash and the warning buzzer sounds constantly.
See Service Manual for details.
2. The second step (5 seconds duration) performs a test to verify the LEDs to illuminate
and the audible warning to sound.
Note: This check is automatic after engine starts.
After the two step check, during operation of the machine when LSI power is on, press
any of the following buttons (2), (3) or (4) to verify the audible warning sounds properly.
31211476
Section 8 - Additional Checks
8
ON0630
OZ0840
1
2
3
4
ON0730
8-1