Maintenance And Care - Flex XFE 15 125 18.0-EC Instruction Manual

Instruction manual
Preselecting the speed
CAUTION
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
– To set the operating speed, move the dial
to the required value.
– Gently press the switch to accelerate the
power tool up to the preselected speed.
NOTE
If an overload or overheating occurs during
continues operation, the power tool
automatically reduces the speed until the
power tool has cooled down adequately.
Operating informations
CAUTION
When the power tool is switched off,
the polishing tool continues running briefly.
NOTE
Following a tool change (e.g. wool pad
instead of polishing sponge), the difference
in weight may increase the vibrations.
Change the operating speed with the
adjusting wheel until the vibrations have
been reduced.
12
XFE 15 125 18.0-EC / XFE 15 150 18.0-EC / XCE 8 125 18.0-EC
– Switch on the machine before placing it
on the surface which is to be polished and
run the polisher up to the set speed.
– Move the polishing tool without pressure
and make circular, overlapping
movements on the surface to be polished
in order to achieve good polishing results
and to prolong the service life of the tool.
– If using a polishing paste, use the
respective tool for each paste.
For further information on the manufacturer's
products go to www.flex-tools.com.

Maintenance and care

WARNING
Risk of electric shock! Before carrying out
any work on the power tool, always remove
the battery.
Cleaning
Regularly clean the power tool and venti-
lation slots. Frequency of cleaning is depen-
dent on the material and duration of use.
Regularly blow out the housing interior and
motor with dry compressed air.
CAUTION
Risk of injury! Wear safety glases while
using compressed air.
All plastic parts should be cleaned with soft
damp cloth. NEVER use solvents to clean
plastic parts. They could possibly dissolve
or otherwise damage the material.