Changing The Stitch Density; Changing The Pattern Length - Brother NX-600 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
UTILITY STITCHES

Changing the stitch density

If a decorative satin stitch has been selected, the
stitch density can be changed.
a Select a decorative satin stitch
b Press (Settings key) in the operation panel.
The settings screen appears.
c Press , , and
is selected.
d Press (OK key).
The screen for specifying the stitching
density of the decorative satin stitch appears.
e
Press and until the desired density is
selected.
Select for coarser stitching or select
finer stitching.
f
Press (OK key).
The initial stitch screen appears again, and
the stitching density is changed.
CAUTION
● If the stitching density is too fine,
depending on the needle, the stitches may
be bunched together, causing the needle
to break.
120
.
(Arrow keys) until
for

Changing the pattern length

The length of one part of a satin stitch can be set to
one of five sizes.
a Select a satin stitch
b Press (Settings key) in the operation panel.
The settings screen appears.
Press , , and
c
is selected.
d
Press (OK key).
The screen for changing the length of a satin
stitch appears.
e Press and until the desired ratio is
selected.
The length can be set within the range of
and .
The satin stitch length is changed.
f Press (OK key).
The initial stitch screen appears again.
.
(Arrow keys) until