Threading The Needle - Brother NX-600 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Threading the needle

The needle threader can be used with needle size
75/11 through 100/16. For more details on the
needle, refer to "Needle types and their uses" (page
34).
a With your left hand, hold the end of the thread
passed through the needle bar thread hook,
and then pass the thread through the thread
guide discs from the front to the back.
a Thread guide discs
b Pass to the back.
c Pass through the slit.
b Cut the thread with the cutter on the left side
of the machine.
a Thread cutter
1
2
3
1
5
c Lower the presser foot lever.
a Presser foot lever
The presser foot is lowered.
d
Lower the needle threader lever until it clicks.
1
a Needle threader lever
The thread is passed through the eye of the
needle.
e Release the needle threader lever.
Carefully pull on the loop of thread passed
f
through the eye of the needle to pull out the
end of the thread.
g Raise the presser foot lever, pass the thread
through the presser foot, and then pull out
about 5 cm (2 inch) of thread toward the rear
of the machine.
1
a 5 cm (2 inch)
The upper threading is finished.
1
Upper Threading 27