Adjusting The Pressure Of The Presser Foot; Removing The Presser Foot Holder - Brother NX-600 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Adjusting the pressure of the
presser foot
The amount of pressure that the presser foot applies
to the fabric can be adjusted.
a Lower the presser foot lever.
a Presser foot lever
b Turn the presser foot dial at the back of the
sewing machine.
The scale on the dial indicates the range from 1
(weak) to 4 (strong). Turn the dial to the right
(smaller number) to decrease the pressure. Turn
the dial to the left (larger number) to increase
the pressure.
Strong
c When you are finished sewing, reset the dial to
3 (standard).
1
Weak
3
Removing the presser foot
holder
Remove the presser foot holder when cleaning the
sewing machine or when installing a presser foot that
does not use the presser foot holder, such as the
quilting foot. Use the screwdriver to remove the
presser foot holder.

■ Removing the presser foot holder

Remove the presser foot.
a
• For details, refer to "Replacing the presser
foot" (page 37).
Use the screwdriver to loosen the presser foot
b
holder screw.
1
a Screwdriver
■ Attaching the presser foot holder
a Align the presser foot holder with the lower-
left side of the presser bar.
b Hold the presser foot holder in place with your
right hand, and then tighten the screw using
the screwdriver in your left hand.
1
a Screwdriver
Replacing the Presser Foot 39