Overcasting Using The Side Cutter - Brother Innov-is 2500D Operation Manual

■ Overcasting Using the Side Cutter

By using the side cutter, you can do overcasting while cutting the fabric.
• Make sure to only select one of the stitches listed below. Using another stitch may cause the needle to hit the presser
foot and break, possibly causing injury.
Memo
Do not use the needle threader when the side cutter is attached. Thread the needle manually, or only attach the side cutter
after threading the needle using the needle threader.
Stitch Stitch name
With side cutter
With side cutter
With side cutter
With side cutter
With side cutter
a
Follow the steps on page 34 to remove the
presser foot.
b
Position the fork on the side cutter's
operating lever onto the needle clamp screw.
b
a Needle clamp screw
b Operating lever
Memo
Make sure that the fork of the operating lever is set
onto the needle clamp screw firmly.
CAUTION
Presser
Applications
foot
Straight stitch while cutting
fabrics
Zigzag stitch while cutting fabrics
Overcasting stitch while cutting
fabrics
Overcasting stitch while cutting
fabrics
Overcasting stitch while cutting
fabrics
a
Stitch width
[mm (inch.)]
Auto. Manual
0.0 0.0 - 2.5
(0) (0 - 3/32)
3.5 3.5 - 5.0
(1/8) (1/8 - 3/16)
3.5 3.5 - 5.0
(1/8) (1/8 - 3/16)
5.0 3.5 - 5.0
(3/16) (1/8 - 3/16)
5.0 3.5 - 5.0
(3/16) (1/8 - 3/16)
c
Position the side cutter so that the side cutter
pin is aligned with the notch in the presser
foot holder, and then lower the presser foot.
a
b
a Notch in presser foot holder
b Pin
→ The side cutter is attached.
SEWING THE STITCHES
Stitch length
Twin
[mm (inch.)]
needle
Auto. Manual
2.5 0.2 - 5.0
NO
(3/32) (1/64 - 3/16)
1.4 0.0 - 4.0
NO
(1/16) (0 - 3/16)
2.0 1.0 - 4.0
NO
(1/16) (1/16 - 3/16)
2.5 1.0 - 4.0
NO
(3/32) (1/16 - 3/16)
2.5 1.0 - 4.0
NO
(3/32) (1/16 - 3/16)
3
65