Setting The Bobbin - Brother Innov-is 2500D Operation Manual

g
Pass the thread through the thread guide.
a
Thread guide
h
Pass the thread under the pin on the bobbin
winding pretension disk and guide, and then
pass it around the pretension disk.
* Make sure that the thread passes under the
pretension disk.
a
b
a
Pin
b
Pretension disk
i
g
Follow steps through

Setting the Bobbin

This section describes how to set a bobbin wound with
thread into the machine. You can begin sewing without
pulling up the bobbin thread. If you wish to pull up the
bobbin thread, for example, when sewing gathers,
follow the procedure described in the next section.
CAUTION
• Use a bobbin thread that has been correctly wound.
Otherwise, the needle may break or the thread
tension will be incorrect.
a
j
on page 25.
LOWER/UPPER THREADING
a
Press the "Presser Foot Lifter" button to raise
the presser foot.
b
Slide the bobbin cover latch to the right, and
then remove the bobbin cover.
a
a
Bobbin cover
b
Latch
c
Hold the bobbin with your right hand and hold
the end of the thread with your left hand.
d
Insert the wound bobbin into the bobbin case
so that the thread unwinds in the direction of
the arrow.
CAUTION
• Be sure to hold down the bobbin with your finger
and unwind the bobbin thread correctly. Otherwise,
the thread may break or the thread tension will be
incorrect.
e
Lightly hold down the bobbin with your right
hand, and then, while slightly pulling the
thread with your left hand, guide it through
the groove.
b
27
1