Removing The Embroidery Unit - Brother Innov-is 2500D Operation Manual

e
Press .
→ The carriage moves to its initial position.
CAUTION
• Keep your hands and foreign objects away from the
embroidery carriage and frame when the machine is
embroidering. Otherwise, injury may result.
Note
If the machine was not initialized correctly, the initial
screen may not appear. This is not a sign of a
malfunction. If this occurs, turn the machine off, then
on again.
f
The following message will disappear after 15
seconds or press
next step.
Note
• The confirmation message to lower the
frame-securing lever after the carriage moves to its
initial position is displayed.
• Continue with pattern selection and remember to
lower the frame-securing lever when the embroidery
frame is attached.
→ Pattern selection screen appears.

■ Removing the Embroidery Unit

a
b
c
to move to the
BEFORE EMBROIDERING
Press or , and then press
→ The carriage moves to the storage position.
CAUTION
• Always remove the embroidery frame before
pressing . Otherwise, the frame may strike the
embroidery foot, and possibly cause injury.
• The embroidery unit will not fit in the storage box/
case if this step is not done.
Note
If the carriage does not move to the storage position,
the embroidery unit cannot be put into its storage box/
case.
Turn off the machine.
Note
Be sure to turn off the machine before removing the
embroidery unit, otherwise damage to the machine
may result.
Press the release button under the end of the
embroidery unit, and then pull the unit away
from the machine.
a Release button
CAUTION
• Do not carry the embroidery unit by holding the
release button compartment.
.
a
123
5