Adjustments During The Embroidery Process; If The Bobbin Runs Out Of Thread - Brother Innov-is 2500D Operation Manual

ADJUSTMENTS DURING THE EMBROIDERY PROCESS

If the Bobbin Runs Out of Thread

When the bobbin begins to run out of thread during
embroidering, the machine will stop and the message
below will appear. Press
directions below to rethread the lower threading. If very
little sewing remains, you can sew 10 final stitches
without rethreading the machine by pressing
The machine will stop after sewing the 10 stitches.
a
Press .
b
Press .
→ The carriage will move and the thread will be
automatically cut.

ADJUSTMENTS DURING THE EMBROIDERY PROCESS

c
and follow the
.
d
e
f
g
Raise the frame-securing lever, and then
remove the embroidery frame.
* Be careful not apply strong force to the fabric at this
time. Otherwise, the fabric may loosen in the frame.
Note
• Be careful not to apply a strong force to the hooped
fabric.
• When removing and reattaching the embroidery
frame, do not allow the frame to hit the carriage or
the presser foot, otherwise the pattern may become
misaligned.
Replace the bobbin with a full one.
Press .
Reattach the embroidery frame.
To return to the point in the pattern where
sewing was stopped, follow steps
f
in the next section.
Memo
For best results, return to a point 2 or 3 stitches before
sewing stopped.
5
c
through
145