Eyelet Stitching - Brother Innov-ís 1000 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Eyelet Stitching

Eyelets, such as those on belts, can be sewn. Three sizes of eyelets are possible: 7 mm, 6 mm and 5 mm
(1/4, 15/64 and 3/16 inch).
Stitch Name Pattern
Eyelet stitch
a Attach monogramming foot "N".
• For details, refer to "Replacing the presser
foot" (page 42).
b Select stitch
• For details, refer to "Selecting stitching" (page
49).
c Adjust either the stitch width or the stitch
length to select the desired eyelet size.
a 7mm
b 6mm
c 5mm
• For details, refer to "Adjusting the stitch
width" (page 56) and "Adjusting the stitch
length" (page 57).
Application
62 Sewing eyelets, for example, on
belts
62
.
1 2 3
Stitch Width
[mm (inch)]
Auto Manual Auto
7.0, 6.0 or
7.0 5.0 7.0
(1/4) (1/4, 15/64 (1/4)
or 3/16)
d Lower the needle into the fabric at the
beginning of the stitching, and then lower the
presser foot lever.
e Start sewing.
Once sewing is completed, the machine
automatically sews reinforcement stitches,
then stops.
f Use the eyelet punch to cut a hole in the
center of the eyelet.
• When using the eyelet punch, place thick
paper or some other protective sheet under
the fabric before punching the hole in the
fabric.
Memo
If thin thread is used, the stitching may be
too open. If this occurs, sew the eyelet twice
before removing the fabric, one on top of the
other.
Stitch Length
Presser
[mm (inch)]
Foot
Manual
7.0, 6.0 or
5.0
N
(1/4, 15/64
or 3/16)
Eyelet Stitching 107
3