Brother Innov-ís 1000 Operation Manual page 87

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
UTILITY STITCHES
■ Changing the density of the stitching
Adjust the stitch length.
• For details, refer to "Adjusting the stitch
length" (page 57).
• If the fabric does not feed (for example, if it is
too thick), decrease the density of the
stitching.
■ Changing the stitch width
Adjust the stitch width.
• For details, refer to "Adjusting the stitch
width" (page 56).
Memo
Before sewing buttonholes, check the stitch
length and width by sewing a trial
buttonhole on a scrap piece of fabric.
86
■ Sewing buttonholes on stretch fabrics
When sewing buttonholes on stretch fabrics, use
a gimp thread.
Hook the gimp thread onto the part of
a
buttonhole foot "A" shown in the illustration.
b It fits into the grooves, and then loosely tie it.
c Attach buttonhole foot "A".
• For details, refer to "Replacing the presser
foot" (page 42).
52
d Select stitch or
Adjust the stitch width to the thickness of the
e
gimp thread.
f Lower the presser foot lever and the
buttonhole lever, and then start sewing.
g When sewing is finished, gently pull the gimp
thread to remove any slack.
Use a handsewing needle to pull the gimp
h
thread to the wrong side of the fabric, and
then tie it.
53
.