Adjusting The Thread Tension - Brother Innov-ís 1000 Operation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Select the pattern you wish to recall.
b
Switch screens using
and
a
a Total amount of memory used
b Total amount of memory space
c Number of the currently displayed page from the
total number of pages
The selected pattern is shown in reverse
highlighting.
c Press
To delete the stored pattern, press
The stored pattern is recalled.
The sewing screen appears, and you can
embroider the recalled pattern.
Note
Only the embroidery patterns and the
alphabet characters can be stored in the
machine's memory.
Characters saved from an embroidery card
must have the embroidery card inserted in
the machine in order to retrieve the memory
saved from the embroidery card.
(Previous page key)
(Next page key).
b
.

Adjusting the thread tension

If embroidery fails, it is difficult to undo the thread
and the fabric may be damaged. Before
embroidering, use a scrap of the same fabric to check
the adjustment of the thread tension, etc.
c
To adjust the thread tension, press
key).
Press
Press
. ■ Correct thread tension
The thread tension is correct when upper thread
is just visible on back of the fabric.
a Right side
b Wrong side
■ Upper thread is too tight
The lower thread will be visible on the front of the
fabric. In this instance, decrease the upper thread
tension.
a Right side
b Wrong side
■ Upper thread is too loose
The upper thread has slack. In this instance,
increase the upper thread tension.
a Right side
b Wrong side
to weaken the thread tension.
to tighten the thread tension.
1 2
1 2
1 2
Editing and Saving Patterns 159
(Settings
4