Attaching The Embroidery Frame - Brother Innov-ís 1000 Operation Manual

Computerized sewing and embroidery machine
Hide thumbs Also See for Innov-ís 1000:
Table of Contents

Advertisement

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —

Attaching the Embroidery Frame

This section describes how to attach the embroidery frame.
Attaching the embroidery
frame
a
Wind the embroidery bobbin thread onto the
bobbin and set it into the bobbin case.
• For details, refer to "Winding/Installing the
Bobbin" (page 23).
b
Raise the presser foot lever.
a Presser foot lever
c
Pass the embroidery frame under the presser
foot while raising the presser foot lever even
further.
CAUTION
● Do not hit the needle with your finger or
the embroidery frame. It may cause injury
or needle breakage.
d
a
● Correctly set the embroidery frame into
While lightly holding the lever on the frame
holder to the left, align the two pins on the
embroidery frame holder with the mounting
bracket on the frame, and then press the frame
into the embroidery frame holder until a click
is heard.
1
a Lever
b Pins
• Be sure to insert both pins. If only the forward
or the back pin is inserted, the pattern may
not turn out correctly.
CAUTION
the embroidery frame holder. Otherwise,
the presser foot may hit the embroidery
frame, resulting in injury.
Attaching the Embroidery Frame 143
2
4

Advertisement

Table of Contents
loading

Table of Contents