Brother Innov-ís 1000 Operation Manual page 78

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
d Raise the presser foot lever to check that the
side cutter is securely attached.
e Pass the upper thread under the side cutter,
and then pull it out toward the rear of the
sewing machine.
f Select a stitch.
• For details, refer to "Selecting stitching" (page
49).
g Make a cut of about 2 cm (3/4 inch) long in
the fabric at the beginning of the stitching.
a 2 cm (3/4 inch)
1
h Position the fabric in the side cutter.
The cut in the fabric should be positioned over
the guide plate of the side cutter.
a
a Guide plate
• If the fabric is not positioned correctly, the
fabric will not be cut.
i Lower the presser foot lever, and then start
sewing.
A seam allowance is cut while the stitching
is sewn.
• If the stitching is sewn in a straight line
the seam allowance will be about 5 mm
(3/16 inch).
1
a 5 mm (3/16 inch)
Memo
The side cutter can cut as much as one layer
of 13-oz. denim.
After using the side cutter, clean it by
removing any lint or dust.
If the side cutter can no longer cut fabric,
use a rag to apply a small amount of oil to
the cutting edge of the cutter.
63
Overcasting Stitches 77
3
,