Servomotor (Sqm10.1 - Riello RS 1000/M BLU Manual

4.13 Servomotor (SQM10.1....)

Warnings
To avoid accidents, material or environmental
damage, observe the following instructions!
Avoid opening, modifying or forcing the actua-
WARNING
tors.
 All interventions (assembly and installation operations,
assistance, etc.) must be carried out by qualified personnel.
 Before modifying the wiring in the connection area of the
servomotor, fully disconnect the burner control device from
the power supply (omnipolar separation).
 To avoid the risk of electrocution, protect the connection ter-
minals in a suitable manner and correctly fix the cover.
 Check the wiring is in order.
 Falls and collisions can negatively affect the safety func-
tions. In this case, the servomotor must not be operated,
even if it displays no evident damage.
Assembly notes
• Check the relevant national safety standards are respected.
• During the assembly of the servomotor and the connection of
the damper, the gears can be disengaged by means of a le-
ver, allowing the drive shaft to be easily adjusted in both ro-
tation directions.
20145860
Technical description of the burner
14 GB
S8413
Technical data
Operating voltage
Auxiliary and limit switch-
es switching capacity
Angular positioning
Assembly position
Protection level
Safety class
Weight
Actuator motor
Power absorption
Environmental conditions:
Operation
Climatic conditions
Mechanical conditions
Temperature range
Humidity
AC 220...240V, 50 Hz –15 % / +10 %
AC 220 V, 60 Hz –15 % / +10 %
10 (3) A, AC 24...250 V
up to 160 ° (base scale)
optional
IP 54, DIN 40050
GB
approx. 1.7 kg
synchronous motor
9 VA
DIN EN 60 721-3-1
Class 1K3
Class 1M2
-20...+70°C
< 95% RH
Fig. 7
Tab. G