Model Number; Serial Number; Product Information Plate; Generator Vent - Cleveland Gemini 24CGA6.2S Operation Installation Maintenance Manual

NOTE TO INSTALLER: There are some significant differences in the installation procedures between the
24CGA6.2S,
24CGA10.2ES units. Pay close attention to section headings for specific installation instructions
for each model listed.
B. SERIAL NUMBER
During manufacture, Gemini Steamers are
assigned individual serial numbers. Whenever
any inquiry is made with Cleveland Range
regarding a steamer the serial number should
be referenced.
C. PRODUCT INFORMATION PLATE
The Product Information Plate on the left side of
the unit lists the model and serial number of the
steamer. Figure 1-1 illustrates a typical Gemini
Product Information Plate. The rating plate also
lists power and wiring requirements.
D. GENERATOR VENT – IMPORTANT
IMPORTANT
When installing this
circumstances should the Steam Vent (See
Figure 1-2), be removed, capped or attached to
piping of any kind.
This fitting is an auxiliary safety intended to
prevent any pressure from building up in the
generator in the unlikely event the steam outlets
of the steamer should become plugged or
restricted.

CHAPTER 7 INSTALLATION INSTRUCTIONS

A. GENERAL
This equipment should only be installed by qualified, professional plumbers, pipe fitters, and
electricians.
•
The steamer is to be installed to comply will the applicable Federal, State or Local Plumbing Codes,
with the National Fuel Gas Code, ANSI Z223.1-(latest edition) or the Natural Gas Installation Code
CAN/CGA-B149.1 or the Propane Installation Code CAN/CGA-B149.2 as applicable, The National
Electrical Code, ANSI/NFPA No. 70-(latest edition) or the Canadian Electrical Code, CSA C22.2 as
applicable, the Food Service Sanitation Manual of the Food and Drug Administration (FDA) and all
applicable state and local codes and regulations.
24CCG10.2 and the
steamer, under
STEAMSAVER™
Figure 1-1 Gemini Product Information Plates
no
19
24CGA6.2SES, STEAMSAVER™
Figure 1-2 Generator Vent