Print Configuration Page; Functions; Led Functions; Factory Default Setting - Brother 1240 Service Manual

CHAPTER 2 INSTALLATION AND BASIC OPERATION
6.1.3

Print configuration page

Press the Network Test button for less than 5 seconds to print a configuration page.
6.2

Functions

6.2.1

LED functions

L-LED (green): Link activity
This LED is on if there is a valid connection to the network (either 10BaseT or 100BaseTX). It
is off if no network is detected.
F-LED (orange): Fast Ethernet
This LED will be on if the print server is connected to a 100BaseTX Fast Ethernet network. It
is off if the print server is connected to a 10BaseT network.
A-LED (green): Transmission activity
This LED will blink as the print server receives or transmits data.
6.2.2

Factory default setting

If you wish to reset the print server back to its default factory settings (resetting all information
such as the password and IP address information), hold down the Network Test button for
more than 5 seconds.
TEST button
Fig. 2-32
L-LED F-LED A-LED
(green) (orange) (green)
Fig. 2-33
2-18