Brother 1240 Service Manual page 92

CHAPTER 4 DISASSEMBLY AND RE-ASSEMBLY
(14) Lift and remove the heat roller. The heat roller gear will also come off.
(15) Remove the heat roller bearing from the left hand end of the heat roller. To remove the
bearing at the gear side, first remove the two washers, then remove the bearing.
!
CAUTION:
Never touch the surface of the heat roller.
NOTE:
When re-assembling the heat roller to the fixing unit frame, place the two projections at the
right hand side of the roller onto the bosses on the frame as shown in the figure below.
Heat roller bearing
Heat roller bearing
Washer
(boss)
Heat roller
Fig. 4-39
Heat roller gear
(projection)
Fig. 4-40
4-22
Heat roller bearing
Washer
Heat roller gear
Heat roller