Control Panel - Whynter ARC-147WF Instruction Manual

Control Panel

The SWING button moves the air louver, evenly distributing the air into the room. When the SWING button is pressed, the flap
will begin to move forwards and backwards alternatively. If pressed again, the flap will be locked into its current position. When
the button is next pressed, the flap will start to move forwards and backwards again.
Press to change modes. Controls the 3 function modes: COOL, FAN, and DRY.
Press to turn on or off the front and top panel lights.
Auto turn off and on
With the air conditioner operating in any function mode, press the TIMER button. The TIMER light will come on. Set the desired
time delay OFF or ON hours by pressing the UP and DOWN buttons. The time increments are at 0.5 hour to up to 10 hours,
followed by 1 hour increment up to 24 hours. When the delay time set has elapsed, the air conditioner either switches on or off
(depending on which auto function is chose). To cancel the delayed switch off function, turn off the air conditioner or adjust the
time setting to 0.0.
• Press to adjust the temperature setting.
• The default display is room temperature.
• In cooling mode, when + or - button is pressed, the set temperature is displayed and may be adjusted. After a few seconds the
display will revert back to room temperature. Temperature is only adjustable in cool mode.
The Fan Speed Control has 3 settings: Low, Medium, High. Fan speed indicator illuminates according to the selected fan speed.
Press to turn the air conditioner on and off.
In this mode, the air conditioner cools and dehumidifies the room. To activate this function mode, press the MODE button until
the COOL indicator light comes on. When the cooling mode is set, the compressor will start in approximately 3 minutes. In
cooling mode, hot air is exhausted from the outdoor exhaust port and the exhaust hose must be connected to exhaust out the
hot air. Note : The air exchange hoses must vent outside the room when using cool mode.
Page 10
 