Whynter ARC-147WF Instruction Manual page 11

Control Panel
Dehumidify Mode
In this mode, the air conditioner only dehumidifies the room, the compressor will activate intermittently depending on the
ambient temperature and the fan speed is set to LOW. To activate this function mode, press the MODE button until the DRY
indicator light is displayed. Please note that when switching function mode, there will be an approximately 3 minute transition
time. In dehumidifying mode, the exhaust hose does not need to be vented. If the exhaust hose is vented, the room will be
cooled as it dehumidifies. To prevent cooling, remove the exhaust hose from the window kit and allow the warm air from the
rear to be re-circulated into the room. If room temperature is higher than 77°F, the fan speed can be adjusted. If room
temperature is lower than 77°F, the fan speed is set at Low.
In this mode, only the fan of the air conditioner runs and circulates the air in the room. To activate this function mode, press the
MODE button until the FAN indicator light comes on. In this function mode, the temperature cannot be set.
.
cted to exhaust the cold air produced by the unit. If outside temperature is lower than room temperature, the air intake hose
should be removed, and the included cover placed onto the air intake fixture. The unit will take in air from the room air filter.
After 250 hours of operation, the indicator light will glow to remind you to clean the filter. Remove the filter and clean it.
Note : After switching the air conditioner off, you must wait 3 minutes before switching it back.
Tank Full
If the internal tank becomes full, the Tank Full indicator will illuminate and the unit will not operate until the unit has been
drained.
Page 11
 