ADTRAN TRACER 4106 Plan A System Manual page 45

TRACER 4106/4206 System Manual
D. T1 Status (Error/Alarm Only)
A visual status of current errors/alarms on the T1 interfaces (for both the local and remote TRACER
systems) is provided on the TRACER 4106/4206 System Status menu page.
displayed in reverse highlight indicates an active error or alarm condition. Individual T1 status pages
(accessible from the main menu) provide detailed T1 information.
E. Remote TRACER Status
The right portion of the TRACER 4106/4206 System Status menu page reports the status of the remote
TRACER 4106/4206 (the system across the wireless link from the active terminal). If the RF link is
down in either direction,
information.
F. Local TRACER Status
The left portion of the TRACER 4106/4206 System Status menu page reports the status of the local
TRACER 4106/4206 (the system where the active terminal is attached).
G. Site Name
The field provides a user-defined alphanumeric description (up to 25 characters) for the
S N
ITE AME
TRACER 4106/4206 system. This field is defined from the TRACER 4106/4206 System Options
menu page.
H. Frequency Plan
Displays the frequency plan (A or B) for the TRACER 4106/4206 unit. For an operational
TRACER 4106/4206 system you should have a frequency plan A radio at one end of the link and a
frequency plan B radio at the other end of the link.
I. Rx Quality
Displays an indicator of receive signal quality that is not necessarily related to receive signal level (for
both the local and remote units) using a series of symbols (
the signal quality. This indicator is related to signal-to-noise ratio and features a colon (:) marker to
-6
indicate 10 bit error rate. This indicator is useful as a diagnostic tool to help identify interference, as
the system may have high receive signal level and poor signal quality in situations where interference
is an issue.
J. Rx Power
Displays the approximate receiver levels (for both the local and remote units) using a series of symbols
( # ). The more symbols (
remote end data is unavailable,
K. Tx Power
Displays the approximate transmitter levels (for both the local and remote units) using a series of
symbols ( # ). The more symbols (
direction, and remote end data is unavailable,
symbols ( # ).
L. Navigation Reminders
Displays system navigation reminders. For more details on system navigation, refer to Navigating the
Terminal Menu on page 42.
612804206L2-1A
D N A is displayed in place of the remote system status
ATA OT VAILABLE
# ) displayed, the stronger the signal. If the link is down in either direction,and
D N A
ATA OT VAILABLE
# ) displayed, the stronger the signal. If the link is down in either
D
© 2004 ADTRAN, Inc.
Section 5 User Interface Guide
). The more symbols displayed, the better
#
is displayed in place of the symbols (
N A is displayed in place of the
ATA OT VAILABLE
T1A through T1D
# ).
45