Section 4 Network Turnup Procedure
1.
INTRODUCTION
This section discusses the installation process of the TRACER 4106/4206 system.
Changes or modifications not expressly approved by ADTRAN could void the user's
authority to operate the equipment.
2.
TOOLS REQUIRED
The tools required for the installation of the TRACER 4106/4206 are:
•
VT100 terminal or PC with terminal emulation software
•
RS-232 (DB-25 male for TRACER 4106/4206) cable for connecting to terminal
To prevent electrical shock, do not install equipment in a wet location or during a lightning
storm.
3.
UNPACK AND INSPECT THE SYSTEM
This system MUST be installed by qualifed service personnel in a Restricted Access
Location.
Each TRACER 4106/4206 is shipped in its own cardboard shipping carton. Open each carton carefully and
avoid deep penetration into the carton with sharp objects.
After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in
transit, immediately file a claim with the carrier, then contact ADTRAN Customer Service (see Customer
Service, Product Support Information, and Training information in the front of this manual).
Contents of ADTRAN Shipment
Your ADTRAN shipment includes the following items:
•
TRACER 4106/4206 Unit
•
TRACER 4106/4206 Documentation CD
•
Four T1 Straight Through (RJ-48 to RJ-48) Cables
36
© 2004 ADTRAN, Inc.
TRACER 4106/4206 System Manual
612804206L2-1A