Table of Contents
Advertisement
SuperSix EVO CX/SE OMS
Seat Binder
Key points:
•
The internal seat binder system consists of a sliding clamp assembly (1) and a nut base (2)
permanently bonded into the frame.
•
Periodically, the seat binder should be removed and both the seat binder and the frame serviced.
To service the binder:
1.
Remove the seat post, see previous page.
2. Use a 4 mm hex key and turn grub screw (d)
slowly clockwise until the seat binder (1) is
disengaged from the nut base (2).
3. Use the 4 mm hex to push the clamp out
through the seat tube opening.
4. Clean the clamp, inside of the frame with
a clean shop towel wetted with rubbing
alcohol. Take care not to soak the clamp
where the grub screw is assembled.
NOTICE
Solvents will wash out the lubricant and the
assembly will have to be re-greased which will
require disassemby.
5. Check the condition of the seat binder, the
seat post and frame opening. All surfaces
should be smooth. If they are not, the seat
binder (1) should be replaced.
138671 Rev 1 (3/21)
To re-install the seat binder:
1.
Re-apply grease and carbon paste as
indicated on the next page. Take care to not
apply grease to the face of the binder.
2. Returning the seat binder (1) to the frame
opening, using the 4 mm hex to guide it to
the nut base.
3
Turn the grub screw (d) counter-clockwise
until the clamp just touches the nut base
(1), then turn the grub screw (d) clockwise
half a turn. This frees the seat binder (1) to
move out of the way of the seatpost during
installation.
16
Technical Information
Seat Binder
Advertisement
Table of Contents
