Asymmetric Integration - Ai Offset - Cannondale SuperSix EVO CX Owner's Manual Supplement

SuperSix EVO CX/SE OMS

Asymmetric Integration - Ai Offset

Rear hub
Centerline of
frame and
wheel rim
This frame requires a 6 mm offset.
To produce this offset, a 12mm gap should be present using the wheel alignment tool, shown above right.
Wheels for this frame will have nearly equal spoke angles and tension on both sides of the hub.
NOTICE
Use only 6 mm offset rear wheels. Incorrect wheel offset can damage your frame.
A standard-dish rear wheel assembled on this frame will result in insufficient tire clearance, leading to rubbing and
serious frame damage. This kind of damage is not covered by the Cannondale Limited Warranty.
Building/Trueing a Wheel:
If you choose to build or to true a rear wheel for use on this bike, make sure the 6 mm offset is present.
Consult with your Cannondale Dealer if you have any questions.
138671 Rev 1 (3/21)
Aligment tool
Centerline of hub
6 mm o set
18
Asymmetric Integration - Ai Offset
Wheel rim
12 mm
Gap required
for 6mm o set
Technical Information
0 mm