Table of Contents
Advertisement
SuperSix EVO CX/SE OMS
Rear Derailleur Mount (RD)
(2X)
M3 X 14mm
2
2 N·m
1.
RD Hanger
2. Screw
To replace:
1.
Remove the rear axle.
2. Remove the screws (2).
3. Remove the hanger (1) and cap (3).
4. Clean the area around the dropout and
inspect the frame carefully for any cracks
or damage. If you find damage, have
the frame inspected by your Cannondale
Dealer .
If the frame is not damaged, apply a light
film of grease between the frame and
hanger. This will help minimize any noise
or "creaking" that might result from slight
movement between the frame and hanger
during movement of the derailleur.
5. Slide the new hanger and cap onto the
frame.
6. Apply Loctite® 242 (or medium strength
thread lock) to the screw threads and
tighten to the specified torque. Do not
over-tighten.
138671 Rev 1 (3/21)
3. Cap
Front Derailleur Mount (FD)
1.
FD mount
2. FD cable screws
3. Di2 cable plug
4. Frame plug
Key points:
•
When installing, clean and apply the
specified thread lock to the screw
threads and tighten screws to the
specified torque. Do not over-tighten.
•
When using a mechanical FD system or
SRAM eTap, install item (4) to reduce the
intrusion of water or debris into the
frame.
•
When using a FD with an electrical wire,
such as Di2, use item (3).
•
Add the BB plug, item (6), that fills hole
of FD cable guide exit when not in use.
•
Check the mount periodically for any
damage. Replace with a new one if
damage is found.
12
Technical Information
Rear Derailleur Mount (RD)
2
3 N·m
(2X)
M5 X 16mm
5. FD mechnical
cable
6. Plug
Advertisement
Table of Contents
