How To Set A New Default; How To Reset To The Factory Settings; Understanding The Error Messages - Brother MFC-495CW User Manual

Chapter 12
IMPORTANT
DO NOT take out the memory card or
USB Flash memory drive while
Photo Capture is blinking to avoid
damaging the card, USB Flash memory
drive or the data stored on them.

How to set a new default

You can save the Scan to Media settings
(Quality, File Type and Auto Crop)
you use most often by setting them as the
default settings. These settings will stay until
you change them again.
a
Press (Scan).
b
Press a or b to choose
Scan to Media.
Press OK.
c
Press a or b to choose
Set New Default. Press OK and 1 to
choose Yes.
d
Press Stop/Exit.
How to reset to the factory
settings
You can restore all the settings you have
changed to the factory settings.
a
Press (Scan).
b
Press a or b to choose
Scan to Media.
Press OK.
c
Press a or b to choose
Factory Reset. Press OK and 1 to
choose Yes.
d
Press Stop/Exit.
108
Understanding the
Error Messages
Once you are familiar with the types of errors
that can occur while you are using
PhotoCapture Center
identify and troubleshoot any problems.
Hub is Unusable.
This message will appear if a Hub or USB
12
Flash memory drive with a Hub has been
put into the USB direct interface.
Media Error
This message will appear if you put in a
memory card that is either bad or not
formatted, or when there is a problem with
the media drive. To clear this error, take
out the memory card.
No File
This message will appear if you try to
access a memory card or USB Flash
memory drive in the drive (slot) that does
not contain a .JPG file.
Out of Memory
This message will appear if you are
working with images that are too large for
the machine's memory. This message will
also appear when a memory card or USB
Flash memory drive you are using does
12
not have enough available space for the
scanned document.
Media is Full.
This message will appear if you are trying
to save more than 999 files in a memory
card or USB Flash memory drive.
Unusable Device
This message will appear if a USB device
or USB Flash memory drive that is not
supported has been connected to the USB
direct interface. For more information, visit
us at http://solutions.brother.com. This
message will also appear if you connect a
broken device to the USB direct interface.
®
, you can easily
12