Parts Of The Device; Commissioning; Settings - Festool OF 1010 REBQ Original Instructions Manual

5

Parts of the device

[1-1]
Router table
[1-2] Stepped stop
[1-3]
Depth stop
[1-4] Locking for trammel unit
[1-5] Nut
[1-6] Spindle stop
[1-7] Handle/Height adjustment
[1-8]
Clamp lever
[1-9] Fine adjuster
[1-10] Depth stop indicator
[1-11] Speed adjusting wheel
[1-12] Locking button
[1-13] Handle
[1-14] On/off switch
[1-15] Extractor connector
[1-16] Grooves for guide bars/parallel side
fence
The specified illustrations appear at the begin­
ning of the Operating Instructions.
Accessories shown or described are not always
included in the scope of delivery.
6

Commissioning

WARNING
Unauthorised voltage or frequency.
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the name plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
may be used.
CAUTION
Heating of the Plug it connection if bayonet
fitting is not completely locked
Risk of burns
► Before switching on the power tool, make
sure that the bayonet fitting at the mains
cable is closed fully and locked.
► Connect and disconnect the mains power
cable - [2].
6.1 Switching on/off
The switch [1-14] is an on/off switch (press =
ON, release = OFF).
The on/off switch with the locking button [1-12]
can be engaged to operate in continuous mode.
Press the on/off switch again to release the
lock.
7

Settings

WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
7.1 Electronics
Speed adjustment
You can continuously adjust the speed within
the speed range using the adjusting
wheel [1-11] (see "Technical data").
This enables you to optimise the cutting speed
to suit each surface.
Material Cutterdiameter [mm]
3 - 14 15 - 25 26 - 35
Rotary controll setting
Hardwood 6 - 4
Softwood 6 - 5
Laminated 6 - 5
chipboard
Plastic 6 - 4
Alumini­ 3 - 1
um
Plaster­ 2 - 1
board
Temperature cut-out
Electronic temperature monitoring is integra­
ted in order to protect against overheating (mo­
tor burnout). The safety electronics system
switches off the motor before a critical motor
temperature is reached. Let the machine cool
down for approximately 3–5 minutes before us­
ing it and/or fully loading it again. The cool-
down time is significantly reduced when the
machine is running (no-load).
Restart protection
The built-in restart protection prevents the
power tool from starting up again automatically
if the power is disconnected when the on/off
switch is pressed. In this case, the power tool
Recom­
mended
cutter ma­
terial
5 - 3 3 - 1 HW (HSS)
6 - 3 4 - 1 HSS (HW)
6 - 3 4 - 2 HW
5 - 3 2 - 1 HW
2 - 1 1 HSS (HW)
1 1 HW
English
17