Fig. 1.) Light the paper or fire lighters. Close the doors until the fuel Your Charnwood Island is fitted with a multi grate to enable wood to is well ignited then load with fuel. Once the fire is up to temperature be burned and ash to be cleared.
Pull the knob out to make the fire burn faster, push it in to make the fire burn slower. To make ash removal easier there is a special Charnwood ash carrier available. This may be purchased from your supplier or, in case of This unique QuattroFlow air control* provides carefully balanced difficulty, from ourselves.
Manufacturer or their approved agents. f) there is sufficient draw in the chimney, (once the chimney is warm a Use only genuine Charnwood replacement parts. draught reading of at least 0.10 inches (2.5mm) water gauge (25 Pa) T H R O A T P L A T E A N D F L U E WA Y should be obtained).
Page 6
Installer will be able to provide the answers to most questions. Your stove very slowly for long periods. Local Charnwood Premier Dealer has a great deal of experience and will also be able to provide helpful advice. Further help is available Check that all flue connections and the blanking plate are well sealed.
Page 7
C H A R N W O O D I S L A N D I n s t a l l a t i o n I n s t r u c t i o n s The outputs were obtained burning seasoned hardwood over a 1.5 H E A L T H A N D S A F E T Y hourly re-fuelling cycle.
The hearth must be at least 12mm (0.5inches) thick. The positioning Soot Door In Side or Rear of the stove and the size of the hearth are governed by building Of Chimney regulations for Class 1 appliances. These building regulations state Register Plate that the hearth must extend in front of the stove by at least 300mm (12 inches) and to the sides of the stove by at least 150mm (6...
P R E L I G H T I N G C H E C K Before initial lighting the following points should be checked :- Alternative Soot Door Positions 1. The bottom grate bars must all be fitted and should move freel y and easily when the riddling mechanism is operated.
Page 10
C H A R N W O O D I S L A N D Flue Outlet To Suit 150mm (6”) Flue Pipe C H A R N W O O D I I I I S L A N D Flue Outlet To Suit 175mm (7”) Flue Pipe Page 10 Island 06.07...
Page 11
Charnwood Island I Issue G Parts List Brick & Throatplate arrangement up to Serial No. 2403 28 Up to Serial No 2865 28a From 2866 onwards Item Part No. Description Item Part No. Description 008/AY62S Door Seal Set Inc. Adhesive...
Page 12
Charnwood Island II Issue G Parts List Brick & Throatplate arrangement up to Serial No. 2658 17 34 33 17 28 Up to Serial No 3284 28a From 3285 onwards Item Part No. Description Item Part No. Description 008/BY35S Door Seal Set Inc. Adhesive...
Page 13
Issue E Charnwood Island III Parts List 28 Up to Serial No 1900 28a From 1901 onwards Item Part Description Item Part Description 008/CY40S Door Seal Set Inc. Adhesive 004/CY32 Air Control Rod 008/FW29 Door Seal Adhesive 004/CY23 Actuator Assembly...
Page 14
A D i v i s i o n o f A . J . W e l l s & S o n s L i m i t e d R e g i s t e r e d i n E n g l a n d N o . 0 3 8 0 9 3 7 1 EN13240:2001 Island I, Island II and Island III Roomheaters fired by solid fuel...
Page 16
Your Local Charnwood Premier Dealer: ® C H A R N W O O D B i s h o p s W a y , N e w p o r t , I s l e o f W i g h t P O 3 0 5 W S , U n i t e d K i n g d o m...
Need help?
Do you have a question about the Island I and is the answer not in the manual?
Questions and answers