Climate / Temperature Class; Electrical Connection - Gram COMPACT 220 Service Manual

Climate / temperature class

Products are tested according to the following climate and temperature classes. Information about
the product's climate and temperature class can be found at the name plate (see fig.12)
Climate class
3
4

Electrical connection

Read the text below thoroughly before electrical connection.
The product is intended for connection to alternating current. The connection voltage (V)
and frequency (Hz) are shown on the name plate in the cabinet (see Fig.6). Only the
supplied cord is to be used.
Never use an extension cord for this appliance!
If a wall socket is placed in a longer distance than the length of the supplied power cord,
contact an electrician to establish a wall socket within the range of the supplied power
cord.
If the product is defective, it must be examined by a properly skilled technician with
proper knowledge of the product during the warranty period.
Outside the warranty period, it is advisable to use the service advised by your dealer. If
this is not the case, assistance is required from a properly skilled technician with proper
knowledge of the product.
Always disconnect the power if interruptions in power supply occur, and when electrical parts are
removed/put on, and before cleaning and maintenance of the product.
Repairing of electrical/technical parts may only be performed by properly skilled technicians with
proper knowledge of the product.
Do not use the product before all coverings are installed, so that live or rotating machine parts
cannot be touched.
The product is not to be used outdoor.
All earthing requirements stipulated by the local electricity authorities must be observed. The plug
and wall socket should then give correct earthing. If necessary, contact an electrician.
Make sure the product is switched off at the socket before service is performed
on electrical parts. It is not sufficient to switch off the product by the
START/STOP key as there will still be voltage to some electrical parts of the
product.
25°C / 60 % RH
30°C / 55 % RH
Temperature
class
L1
M1
-18°C
+5°C
9