General Use - Gram COMPACT 220 Service Manual

Always disconnect the power if interruptions in power supply occur, and when electrical parts are
removed/put on, and before cleaning and maintenance of the product.
Repairing of electrical/technical parts may only be performed by properly skilled technicians with
proper knowledge of the product.
Do not use the product before all coverings are installed, so that live or rotating machine parts
cannot be touched.
The product is not to be used outdoor.
All earthing requirements stipulated by the local electricity authorities must be observed. The plug
and wall socket should then give correct earthing. If necessary, contact an electrician.
Make sure the product is switched off at the socket before service is performed
on electrical parts. It is not sufficient to switch off the product by the
START/STOP key as there will still be voltage to some electrical parts of the
product.

General use

Do not damage the refrigeration system parts.
During normal operation, some parts of the refrigeration system in the compressor
compartment might reach high temperatures and could therefore cause burns if touching
these components.
Do not use electrical devices inside the product.
To ensure correct and efficient air flow in the cabinet, the shaded areas must be kept free of
items.
All items to be stored, that are not wrapped or packed, must be covered in order to avoid
unnecessary corrosion of the inner parts of the cabinet.
If any controller parameters are changed from default, this could cause that the product is not
functioning normally, and harmful temperatures could damage items that are kept inside the
product.
If the product is turned off, wait minimum 3 minutes before turning it on again. This is to
protect the compressor from damage
Maximum loading of wire shelf: 40 kg
Do not store explosive substances such as aerosol cans with flammable propellant in this
appliance.
Be aware, if bottles are stored near the air outlet, they may freeze up and break, causing a risk of
injury (only K and KG products).
Do not overpack the product with foods. Allow some space between them to ensure a good airflow.
Moist or fresh foods and those with a strong smell should be wrapped up in a plastic film or packed
in a container. Otherwise the food may dry out or give their smell to other foods.
Foods containing acetic acid or yeast should be wrapped up in plastic film. Otherwise they may
accelerate corrosion of the evaporator and metal parts, resulting in failure.
10