AEG 43036IW-MN User Manual page 19

2. Put the core temperature sensor into
the socket on the front of the appli-
ance.
3. Activate the appliance.
4. Set the core temperature:
– Press
again and again until
the function core temperature
sensor flashes and the display
shows the core temperature.
– Press
or
onds to set the core temperature.
The display changes to the actual
core temperature.
The core temperature is dis-
played from 30°C.
The default core temperature is
60°C.
8.14 Installing the oven accessories
in less than 5 sec-
5.
Set the oven function (
necessary, the oven temperature (
/ ).
The appliance calculates the approx-
imate end time for the set core tem-
perature again and again. The dis-
play constantly shows the new ap-
proximate end time.
The core temperature sensor
must stay in the meat and in the
core temperature sensor socket
during the cooking operation.
While the appliance calculates
the approximate end time, the
display shows a square that flash-
es.
6. When the meat is at the set core
temperature, an acoustic signal
sounds.
Press a button to stop the signal.
7.
Remove the core temperature sen-
sor plug from the socket and remove
the meat from the oven.
WARNING!
The core temperature sensor is
hot! There is a risk of burns! Be
careful when you remove the tip
and the plug of the core temper-
ature sensor.
8. Deactivate the appliance
The deep pan and the oven shelf
have side edges. These edges
and the shape of the guide-bars
are a special device to prevent
the cookware from slipping.
ENGLISH
19
) and, if