Table of Contents
Advertisement
AT THE END OF YOUR CUTTING SEASON
IMPORTANT: When the unit is going to be
stored for an extended amount of time please
perform the following steps to keep the oil
seals from deteriorating.
1. Spray shaft extensions with a suitable dry
film or similar preservative
2. Pack grease around seal to prevent drying
and cracking
3. Fill the gearbox with enough oil so that it
covers the top of the input seal
4. Remove the breather and replace with an
airtight plug
5. Remember to drain the oil back to the
correct level before using again
6. Check (and replace where necessary)
blades, bolts, and nuts on the cutter.
7. Clean cutter and touch up any rust spots
that may have appeared.
8. Replace any safety decals if damaged.
9. Store rotary cutter in a clean dry location.
Always use a tractor to position
equipment for storage. Never
CAUTION
attempt to move equipment by
hand.
S T O R A G E
33
Advertisement
Table of Contents
