Installing Pto Shaft - Tarter RC306BL Operation And Assembly Manual

A S S E M B L Y
9. Move tailwheel assembly from the
shipping position to the user position by
removing the two retaining bolts, nuts, and
washers (using 3/4" wrench and socket.)
Slide tailwheel back and insert hardware in
slotted hole as shown. Insert hardware to
desired height setting in the rear.
14

INSTALLING PTO SHAFT

1. Begin by removing the snap ring from the
gearbox input shaft.
2. Install slip clutch shield on gearbox using
the (4) supplied bolts and washers that were
previously removed from the manual holder
using a 1/2" socket and extension.