Attaching Chain Guards - Tarter RC306BL Operation And Assembly Manual

3. Push PTO driveline onto input shaft
towards gearbox aligning the holes for the
retaining bolt.
IMPORTANT: With slip clutch PTO only use 1/2"
Grade 8 retaining bolt indicated by 6 lines on
head of bolt as shown.
4. Utilizing the access hole in the slip clutch
guard insert the Grade 8 retaining bolt and
tighten using 3/4" wrench and socket with
extension.
5. Remove safety chain from bag on PTO Shaft
and attach the clip to the side of the slip clutch
shield as shown.

ATTACHING CHAIN GUARDS

1. Using the remaining packaged hardware.
Lay front guard on ground with flange and
cable facing up as pictured.
A S S E M B L Y
(continued on next page)
15