Table of Contents
Advertisement
IMPORTANT: PTO driveline may be too long for some tractor models, causing tractor transaxle
damage. Modify driveline if necessary.
Attach rotary cutter to tractor and check cutter-to-tractor driveline telescoping length
clearance.
(See MAINTENANCE BEFORE EACH USE in Lubrication and Maintenance section.)
• Modify PTO Driveline (If Necessary)
1. To adjust the length, hold the half-shafts
next to each other in the shortest working
position and mark them.
2. Shorten inner and outer guard tubes
equally.
3. Shorten inner and outer sliding profiles by
the same length as the guard tubes.
Final Inspection and Adjustments
MODIFY PTO DRIVELINE
M O D I F Y I N G P T O
4. Round off all sharp edges and remove burrs.
Grease sliding profiles. No other changes
may be made to PTO drive shaft and guard.
5. Chains must be fitted so as to allow
sufficient articulation of the shaft in all working
positions.
6. The PTO drive shaft must not be suspended
from the chains!
17
Advertisement
Table of Contents
