Table of Contents
Advertisement
A S S E M B L Y
2. Lift guard straight up and attach (7) bolts,
nuts, and washers from the front of cutter
using 9/16" socket.
NOTE: Place carriage bolt inside of cutter
facing out.
3. To attach rear guard- use bolts with
spacers provided. Insert bolt from inside of
cutter, then slide spacer on. Attach nut from
outside of chain guard.
NOTE: It is important to install bolts sequentially
rather than starting with both ends. Hand
tighten until all hardware is in place.
16
INITIAL LUBRICATION
1. Before operating – fill gearbox with oil by
removing breather plug A and check plug
B, add EP80W-90 gear oil until level with
check plug hole. Reinstall both plugs.
2. Add grease to all grease fittings: (2)
tailwheel, (2) PTO Shaft cross bearings.
A
A
B B
Advertisement
Table of Contents
