Adjusting Trim Angle; Adjusting Boat Trim - Yamaha VF115 Owner's Manual

Operation
The trim angle of the outboard motor helps
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim
angle depends upon the combination of
boat, engine, and propeller. Correct trim is
also affected by variables such as the load in
the boat, sea conditions, and running speed.
1. Trim operating angle
EMU40422

Adjusting trim angle

EWM02472
WARNING
 Make sure that all people are clear of the
outboard motor when adjusting the trim
angle. Body parts can be crushed be-
tween the outboard motor and the
clamp bracket when the outboard motor
is trimmed or tilted.
 Use caution when trying a trim angle for
the first time. Increase speed gradually
and watch for any signs of instability or
control problems. Improper trim angle
can cause loss of control.
 If the outboard motor is equipped with a
power trim and tilt switch located on the
bottom cowling, use the switch only
when the boat is at a complete stop with
56
the engine off. Do not adjust the trim an-
gle with this switch while the boat is
moving.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
UP
DN
1
1. Power trim and tilt switch
UP
DN
1
1. Power trim and tilt switch
To raise the bow (trim-out), push the "
side of the switch.
To lower the bow (trim-in), push the "
(down) side of the switch.
Make test runs with the outboard motor set at
different trim angles to find the position that
works best for your boat and operating con-
ditions.
EMU27913

Adjusting boat trim

When the boat is on plane, a bow-up attitude
results in less drag, greater stability and effi-
ciency. This is generally when the keel line of
the boat is up about 3 to 5 degrees. With the
ZMU06981
ZMU07849
" (up)
"