JinkoSolar JKM M-72 Series Installation Manual page 5

JKMxxxM-96-J (xxx=210-285, in steps of 5, 96 cells)
JKMxxxM-72-J (xxx=160-215, in steps of 5, 72 cells)
JKMxxxM-96B (xxx=210-285 in steps of 5, 96 cells)
JKMxxxM-72B (xxx=160-215, in steps of 5, 72 cells)
JKMSxxxM-96 (xxx=210-285, in steps of 5, 96 cells)
JKMSxxxM-72 (xxx=160-215, in steps of 5, 72 cells)
JKMSxxxM-96-J (xxx=210-285, in steps of 5, 96 cells)
JKMSxxxM-72-J (xxx=160-215, in steps of 5, 72 cells)
With 6" Quasi-mono c-Si:
JKMxxxP-72L (xxx=255-330, in steps of 5, 72 cells)***
JKMxxxP-60L (xxx=215-275, in steps of 5, 60 cells)
JKMSxxxP-60L (xxx=215-275, in steps of 5, 60 cells)
Notes:
*B: module with black back sheet
**JKMS: the smart module
***L: module with quasi-mono cell
***PP: the EAGLE Series module
***-J4：with solar cell types with 4 busbars
*** (Plus)：the eagle+ Series module
Make sure the array of modules installed within the Maximum permitted system
voltage and the rating current and voltage of the sub-equipments such as regulators
and inverters. The maximum permitted system voltage (DC) of the modules sold in
Europe is 1000V
The assembly is to be mounted over a fire resistant roof covering rated for the
application. Before mounting the module, please consult your local building
department to determine approved roofing materials.
The modules are qualified for application class A: Hazardous voltage (IEC 61730:
higher than 50V DC; EN 61730: higher than 120V), hazardous power applications
(higher than 240W) where general contact access is anticipated (Modules qualified
for safety through EN IEC 61730-1 and -2 within this application class are considered
to meet the requirements for Safety Class II.
- 3 -