Figure 5-4. Removing The Cavity Shield; Figure 5-5. Removing The Pa Shield (Low And Mid Power Models) - Motorola MCS 2000 Service Instructions Manual

5-4 Disassembly & Reassembly and Replacement Procedures: Disassembly to Transceiver Board Level
Remove the PA Shield L
1. Unscrew the three screws that hold the PA shield with T-10 Torx Driver.
2. Remove the PA shield by pulling straight up on the attached handle.

Figure 5-5. Removing the PA Shield (Low and Mid Power Models)

Remove the Transceiver Board E
NOTE: For 800 MHz and 900 MHz radios go to page 6.
Low Power Models
1. Remove the Accessory Connector on the bottom of the radio by sliding a finger into the
recess on the chassis and pushing up on the connector tab to loosen the connection. Lift the
connector out of the recess.
December 6, 2004

Figure 5-4. Removing the Cavity Shield

M P M
OW AND ID OWER ODELS
800 MH
XCEPT Z AND
Cavity Sheild Tabs
PA Section & PCB
Holding Screws (3)
900 MH
Z
68P81083C20-D