Figure 5-22. Inserting Audio Pa Clip; Figure 5-23. Installing Cover Gasket - Motorola MCS 2000 Service Instructions Manual

Hide thumbs Also See for MCS 2000:
Table of Contents

Advertisement

5-18
Disassembly & Reassembly and Replacement Procedures: Transceiver Reassembly High Power Models
1. Install the RF shield by placing it over the chassis with the front and back tabs inside the
chassis and side tabs outside the chassis walls. Push straight down applying even pressure
to the edges of the shield until they rest flush on the chassis wall. Repeat the same operation
for the PA shield.
2. Insert the 18 position connector (black side) through the opening in the chassis into the
female connector on the RF board.
NOTE: The 18 position connector is not symmetrical, therefore the black side must mate to the
connector on the transceiver board.
3. Place a new cover gasket around the chassis being sure it is placed under the locking tabs
and the v-shaped rail shown in
the rail, twist the gasket up and toward chassis between the fingers at the location of the low-
est point of "V". Position the gasket under the rail and release.
4. Insert the 18 position connector (black side) into the female connector through the hole in the
front of the chassis.
5. Carefully guide the bottom cover front hole opening over the 18 position connector. Engage
the bottom cover over the hooks at the front of the chassis, rotate the cover back over the
chassis, and press down until the sides snap into place.
6. Install the accessory connector assembly through the bottom side of the radio. Be sure to
install the connector straight down into the unit because otherwise it will catch on the housing
and no connection will be made.
NOTE: The radio will not function without the accessory connector.
December 6, 2004
Pressure Points

Figure 5-22. Inserting Audio PA Clip

Figure
Gasket twist
direction
Lowest point of gasket
locating feature "V"

Figure 5-23. Installing Cover Gasket

Guide Rail
Audio PA Clip
18 Position Connector,
Female
5-23. To ensure that the gasket remains seated under
Locking Tab
(other tab on opposite
side of chassis)
68P81083C20-D

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents